 | support home  voip voip guides current page |
Connect the Open 824RLW/824RL or 7404VGP to the power, phone line and network to your PC. Turn it on and wait about 1 minute for it to boot up and establish an ADSL signal. Load Internet Explorer.
Type the following in the address bar: 192.168.1.254
When prompted for a username and password, type:
Click on VoIP on the left hand side and then click on Wizard
You will see a screen as follows, click on VoIP User Defined Profile at the bottom.
Click on 'Create' on the next screen
Enter the VoIP settings as follows:
Note For Phone Number, Authentication Username and Authentication Password, enter the details we have provided you for your VoIP account.
Click on Apply and then Return at the bottom of the page.
This will take you back to the VoIP Wizard page. Click on Select Profile for Phone Port 1
Select SpinTelVoIP from the list.
You will then be directed to the main VoIP page which will have all your user settings. Put a tick in 'Same as Phone Port 1' for Phone Port 2. The settings should look similar to the image below. Click on Apply.
The 'General Settings' window should have the following settings. Then click on Apply.
At this stage we should save the settings. You can do so by clicking on Save Config at the bottom. Click on Apply to save the settings to flash.
On the left hand side, click on 'Configuration', then click on 'VoIP' then click on 'Call Features'. The settings should be as follows:
Note If you wish to change any settings here for call forwarding you may. Please note that forwarded calls will incur further call charges.
Click on Apply then click on Ring & Tone on the left hand side.
Ensure the region is set as follows. Then click on Apply.
IMPORTANT VoIP Prioritisation and QoS to ensure optimum quality calls IMPORTANT
Now we're going to ensure our VoIP calls take priority over all other Internet Traffic. On the left hand side click on 'QoS' and then click on 'Prioritization'.
If you use your Internet connection for downloads, you will need to have the following settings and then click Apply
Note If you have a non-default torrent or newsgroups/usenet port set, you must set it here under 'Source / Destination Port'. Source and Destination IP Address Range should be the local computer address of the computer/s downloading via Bittorrent or Usenet / Newsgroups.
Click on 'Outbound IP Throttling' on the left hand side and ensure the settings are as follows. Click on Apply.
Click on 'Inbound IP Throttling' on the left hand side ensure the settings are as follows. Click on Apply.
Now would be a good time to save your settings to the router. You can do so by clicking on Save Config at the bottom. Click on Apply to save the settings to flash.
You can now see if your VoIP Account has been successfully registered in your router by clicking on 'Status' and then 'VoIP Status' on the left hand side.
It should say that your VoIP line is registered. If so you can begin to make and receive calls via VoIP.
You have now setup your Open Router successfully.
